A flat roof on a Merseyside home is usually covered in EPDM rubber, GRP fibreglass or torch-on felt. Most replacements cost £1,400–£2,500, and a single garage is typically £1,000–£2,300. Laid on a sound, insulated deck with a fall of at least 1:80, EPDM and GRP usually last 25 to 30 years or more.
Flat roof replacement prices
Most flat roof replacements on Merseyside cost £1,400–£2,500. That's lower than national guides because most roofs here are small: garages, back extensions, dormers and the flat roofs on terrace outriggers. The price depends on size, the system, how much of the deck is rotten, insulation and access.
| Job | Typical Merseyside price |
|---|---|
| New EPDM roof, single garage | £1,000–£2,300 |
| New flat roof over a kitchen extension | £1,800–£3,500 |
| Re-cover a dormer flat roof, with access | £1,000–£2,500 |
| Torch-on felt, installed, per m² | £75–£115 per m² |
| EPDM rubber, installed, per m² | £105–£155 per m² |
| GRP fibreglass, installed, per m² | £115–£175 per m² |
| Small repair: patch a split or reseal an edge | £150–£500 |
| Replace a damaged section | £500–£1,500 |
Prices as of November 2026. These are typical Merseyside prices. Your quote is fixed in writing after we've seen the roof. Per-m² rates look high on small roofs because trims, outlets, upstands and the skip are spread over fewer square metres.
Is a flat roof cheaper to replace than a pitched one? Usually, yes. Per square metre it runs from £75–£115 per m² in felt to £115–£175 per m² in GRP, against £100–£200 per m² for a tiled pitched roof, and it needs less scaffold. The catch is lifespan: a felt roof may need replacing more than once in the life of a tiled one, so compare the cost per year, not just the quote.
Is a flat roof cheaper to build? Generally, yes: less timber, no loft and simpler scaffold, which is why most extensions and garages have one. You give up loft space and take on a roof that needs more looking after.
Garage roofs built before 2000 may be asbestos cement. That needs testing before any work, and removal from a garage typically adds £950–£3,750. It's usually non-licensed work under the Control of Asbestos Regulations 2012, but it still has to be handled and disposed of properly.
EPDM, GRP or felt: which system?
For most Merseyside garages, extensions and dormers, EPDM rubber is a sound default. GRP is the one to choose if you want to walk on the roof or it has lots of corners and detail, and torch-on felt costs least to lay. All three work if the deck, falls and edges are done properly; none of them survives a rotten deck or bad drainage.
- What is the covering on a flat roof called? The waterproof layer is the membrane. The common types are EPDM, GRP, torch-on or built-up felt (reinforced bitumen membrane) and liquid-applied coatings. A roof coating can extend the life of a sound roof; it won't fix a wet or rotten deck.
- A flat roof you can walk on: GRP with a heavier, walkable laminate, or paving or decking on supports over the membrane. EPDM and felt take light foot traffic for maintenance only. Turning a flat roof into a balcony or terrace usually needs planning permission and proper guarding, so check with your council's planning team first.
- Flat roof rules and standards: BS 6229:2025 is the code of practice for flat roofs and asks for a finished fall of at least 1:80. BS 8217 covers felt. Under Approved Document L, a replaced flat roof should be insulated to 0.16 W/m²K where that's practical. Like-for-like re-covering usually needs no planning permission, but Article 4 conservation areas can control roof coverings, so check with the council.
- Flat roof timbers and span tables: joist size depends on the span, spacing and timber grade. On a new extension the sizes come from published span tables (TRADA) or an engineer, and building control checks them. On a re-cover, we check the joists and boards once the old covering is off.
- Upstands and outlets: the membrane should turn up the wall at least 150 mm above the finished roof, under a flashing, and outlets and gutters must be big enough and kept clear. Most leaks start at these edges.
- Flat roof solar panel mounting: ballasted frames or bolted mounts work on a sound roof. Replace an old covering before the panels go on, or you'll pay to lift them later.
- Flat roof or gable? A pitched roof lasts longer and sheds water faster. A flat roof is cheaper and suits extensions, garages and orangeries, where the flat roof runs round a glazed lantern and the upstand at the lantern kerb needs the same care as a wall.
| EPDM rubber | GRP fibreglass | Torch-on felt | |
|---|---|---|---|
| What it is | One sheet of synthetic rubber, bonded down | Glass-fibre mat and resin laid on site, then topcoated | Layers of reinforced bitumen membrane, heat-bonded |
| How it's laid | Cold, with adhesive | Cold, but the resin needs a dry day to cure | With a gas torch, so fire precautions are needed |
| Joints | Few or none on small roofs | Seamless | Lapped layers |
| Can you walk on it? | Light foot traffic only | Yes, with a walkable finish | Light foot traffic only |
| Typical life (merchant figures) | 25–30 years, often more | 25–30 years, often more | 10–30 years depending on system |
| Best for | Garages, extensions, dormers | Balconies, roofs with lots of detail | Tight budgets, larger simple roofs |


How long flat roofs last
A flat roof in the UK typically lasts 10 to 30 years in felt and 25 to 30 years or more in EPDM or GRP, by merchant figures. The Confederation of Roofing Contractors gives well-maintained torch-on felt 30 years or more, GRP 25 or more and EPDM 50 or more. These are published ranges, not guarantees: poor falls, blocked outlets and foot traffic shorten any of them.
| System | Typical life | Usually due when |
|---|---|---|
| Old built-up felt with chippings | 10–20 years | Patched more than once, cracking, soft in places |
| Modern torch-on felt | Up to about 30 years | Splits at laps, blisters breaking open |
| EPDM rubber | 25–30 years, potentially 50 | Seams or upstands lifting, punctures |
| GRP fibreglass | 25–30 years, potentially 50 | Cracks at joints or trims, topcoat worn through |
How often do flat roofs need replacing? When the covering is splitting, the deck has gone soft, or it's been patched repeatedly. An old felt roof on a 1970s garage or extension is often due well before an EPDM or GRP roof laid on the same street last decade.
How many days does it take to replace a flat roof? A single garage or small extension is typically one to two days. Larger roofs or a full warm-roof build-up take two to three days, longer if it rains, since GRP resin and EPDM adhesive both need a dry deck.
On the Merseyside coast, from Crosby up to Southport, wind lifts loose edges and driving rain finds weak upstands, so edge trims and flashings matter even more there.
Replacing a flat roof: the job
A proper flat roof replacement strips back to the deck, replaces any soft boards, builds in a fall, adds insulation and lays the new membrane with upstands, trims and flashings. Most small roofs are done in one to two days.
- Strip the old covering down to the deck and check every board. Rotten boards are replaced at a rate agreed up front.
- Fit new decking where needed, typically 18 mm OSB3 tongue-and-groove, and build in the fall so water runs to the gutter or outlet.
- Fit a vapour control layer and rigid insulation on top of the deck for a warm roof.
- Lay the new covering with upstands against walls, edge trims and drip details.
- Fit lead or a cover flashing where the roof meets the house, plus new outlets, leaf guards or gutter as needed.
- Clear away the old materials and send you photos of the finished roof.
Can you overlay a flat roof, or reroof over an existing one? Sometimes, if the old roof is dry and well bonded and the manufacturer allows it. If the deck is wet you'd be sealing the problem in, so we check first and usually recommend stripping.
Flat roof fall over 3 m: a finished fall of 1:80 means at least 37.5 mm of drop over 3 m. Designers often aim for 1:40 (75 mm over 3 m) so the roof still reaches 1:80 once it has settled.
Can you walk on a warm flat roof? For maintenance, yes. The insulation boards are rigid and made to take light foot traffic, but it isn't a terrace unless it's designed as one.
Building Regulations: replacing a flat roof's waterproofing counts as renovating a thermal element under Approved Document L. Renew more than half of it and the work is notifiable, and it should be insulated to current standards where practical. That's signed off either by building control or by a roofer registered with a Competent Person Scheme. A warm roof sits higher than the old one, so check how it meets door thresholds, windows and wall flashings.



Flat roof problems: ponding, blisters and leaks
Most flat roof leaks come from standing water, failed upstands, and splits or blisters in an old covering. Water still lying 48 hours after rain means the falls are wrong or an outlet is blocked, and it shortens the life of the roof.
- Standing water on a flat roof after rain: a thin film that dries within a day or two is normal. Deeper ponds that stay are a drainage problem. Clear the outlet first; if the deck has sagged, the fall has to be rebuilt.
- Blisters and bubbles: moisture or air trapped under felt expands in the sun. A small, unbroken blister can be watched; one that has split will let water in.
- Splits, cracks and crazing: an old covering that has lost its flexibility. Patching buys time but rarely years.
- Leaks where the roof meets the wall: the upstand or flashing has failed. This is the most common leak on rear extensions and outriggers.
- A soft or spongy feel underfoot: the deck boards are wet. The roof needs replacing, not patching.
- Moss on a flat roof: is it a problem? Yes, over time. Moss holds water against the membrane and blocks outlets. Brush it off gently and clear the outlets; don't use a pressure washer, a scraper or strong chemicals that can damage the membrane.
Flat roof advantages and disadvantages: flat roofs are cheaper, quicker to build and easy to reach for maintenance. The downsides are a single waterproof layer, total reliance on drainage, a shorter life in felt, and condensation risk in older cold-deck roofs. Flat roof extension problems are usually the same three: poor falls, a weak junction with the house wall, and no insulation.
If water is coming through the ceiling now, get it made safe first. A temporary repair buys time to get proper quotes.


Questions people ask
Should I avoid buying a house with a flat roof?
Not necessarily. Ask the age and type of the covering, look for ponding and ceiling stains, and get a survey. A new roof on a typical kitchen extension costs £1,800–£3,500.
Is a flat roof good or bad?
A modern EPDM or GRP roof on a warm, well-drained deck is a good roof. The bad reputation comes from old felt roofs laid flat, with no insulation and blocked outlets.
What are flat roofs made of in the UK?
A timber deck on joists, often with insulation, covered by a waterproof membrane: EPDM rubber, GRP fibreglass, torch-on felt or a liquid coating. Older roofs may be asphalt or asbestos-cement sheet.
What causes bubbles on a flat roof?
Moisture or air trapped under or between the layers expands when the sun heats the roof. Small unbroken blisters can be left and watched, but split ones need repairing.
Should water sit on a flat roof?
No. A little after rain is normal, but water still there 48 hours later means the fall is wrong or an outlet is blocked. BS 6229 asks for a finished fall of at least 1:80.
What fall do I need for a 4m flat roof?
At 1:80, the minimum finished fall, a 4 m roof needs at least 50 mm of drop. Most roofers design for about 1:40, or 100 mm, so it still drains after settling.
Is it safe to stand on a flat roof?
On a sound roof, for light maintenance, usually yes, but keep away from the edges and off rooflights. If the deck feels soft or flexes, get off it: the boards may be rotten.
Should I clean moss off my flat roof?
Yes. Moss holds water and blocks outlets. Brush it off gently, without a pressure washer or anything sharp.
Why does my flat roof creak or make banging noises?
Usually the deck and joists expanding and contracting as the temperature changes, often at sunrise and sunset. If it comes with a soft deck or a leak, get it checked.
When should I replace my flat roof?
When it's splitting, the deck is soft, it's been patched more than once, or an old felt roof is past 20 years. One leak on a younger roof can often be repaired for £150–£500.
What counts as a flat roof?
Any roof with a pitch of up to 10 degrees. BS 6229, the UK code of practice, covers flat roofs in that range.
What does a flat roofer do?
They strip and re-cover flat roofs, replace rotten decking, build in falls and insulation, and repair splits, blisters and failed upstands, usually on garages, extensions and dormers.
Get a free, fixed quote
Tell us what's wrong. A photo helps. We'll call you back with a fixed price.
